What's the difference between a fraction and a ratio? A fraction is a number that names part of a whole or part of a group. The denominator represents the total number of equal parts the whole is divided into. A ratio is a comparison of two quantities.
Answer:
the pressure reading when connected a pressure gauge is 543.44 kPa
Explanation:
Given data
tank volume (V) = 400 L i.e 0.4 m³
temperature (T) = 25°C i.e. 25°C + 273 = 298 K
air mass (m) = 3 kg
atmospheric pressure = 98 kPa
To find out
pressure reading
Solution
we have find out pressure reading by gauge pressure
i.e. gauge pressure = absolute pressure - atmospheric pressure
first we find absolute pressure (p) by the ideal gas condition
i.e pV = mRT
p = mRT / V
p = ( 3 × 0.287 × 298 ) / 0.4
p = 641.44 kPa
so
gauge pressure = absolute pressure - atmospheric pressure
gauge pressure = 641.44 - 98
gauge pressure = 543.44 kPa
Answer:
I have attached the diagram for this question below. Consult it for better understanding.
Find the cross sectional area AB:
A = (1.6mm)(12mm) = 19.2 mm² = 19.2 × 10⁻⁶m
Forces is given by:
F = 2.75 × 10³ N
Horizontal Stress can be found by:
σ (x) = F/A
σ (x) = 2.75 × 10³ / 19.2 × 10⁻⁶m
σ (x) = 143.23 × 10⁶ Pa
Horizontal Strain can be found by:
ε (x) = σ (x)/ E
ε (x) = 143.23 × 10⁶ / 200 × 10⁹
ε (x) = 716.15 × 10⁻⁶
Find Vertical Strain:
ε (y) = -v · ε (y)
ε (y) = -(0.3)(716.15 × 10⁻⁶)
ε (y) = -214.84 × 10⁻⁶
<h3>PART (a)</h3>
For L = 0.05m
Change (x) = L · ε (x)
Change (x) = 35.808 × 10⁻⁶m
<h3>
PART (b)</h3>
For W = 0.012m
Change (y) = W · ε (y)
Change (y) = -2.5781 × 10⁻⁶m
<h3>PART(c)</h3>
For t= 0.0016m
Change (z) = t · ε (z)
where
ε (z) = ε (y) ,so
Change (z) = t · ε (y)
Change (z) = -343.74 × 10⁻⁹m
<h3>
PART (d)</h3>
A = A(final) - A(initial)
A = -8.25 × 10⁻⁹m²
(Consult second picture given below for understanding how to calculate area)
Answer:
its so simple. u must mind some formulas.
Explanation:
mili->10^(-3)
micro->10^(-6)
nano->10^(-9)
so write the exact number and move "." to left or right depend question.
in this one:
23.5 is 23500000.0 nano with a default dot at the end
for turning to mili u must move the dot 6 steps to left so it will be: 23.5 milimeter.