I believe C is your answer (also, I am also using tht same exact program!)
Answer:
Explanation:add them then divide them by 100 I think
Answer: The changing magnetic field caused by the material's motion induces a current in the coil of wire proportional to the change in field. If a 0 is represented, the magnetic field does not change between the two domains of a bit, so no current is induced as the magnetic material passes the coil.
Answer:
Thin, aluminium and buried underground.
Explanation:
When it comes to electrification of a state or province, some characteristics of the wire to use must be considered. This would help to minimize and avoid power loss and wire burns.
i. The wire to use should be thin, and a quite number can be twisted one against the other so as to increase the surface area for heat dissipation.
ii. Aluminium wire is more preferable for this project. It has a high melting point, and reduces energy loss.
iii. Burying the wire underground through an insulator is the best choice, though expensive but would preserve the wire from external influence.
Answer:
Explanation:
There is electric field between the plates whose value is given by the following expression
electric field E = V /d where V is potential between the plates and d is distance between them
E = 300 / 5 x 10⁻³
= 60 x 10³ N/c
Force on electron = q E where q is charge on the electron
F = 1.6 X 10⁻¹⁹ X 60 X 10³ = 96 X 10⁻¹⁶ N.
Acceleration a = force / mass
a = 96 x 10⁻¹⁶/ mass = 96 x 10⁻¹⁶ / 9.1 x 10⁻³¹
= 10.55 x 10¹⁵ m / s²
For midway , distance travelled
s = 2.5 x 10⁻³ m
s = 1\2 a t²
t =
=
t = .474 x 10⁻¹⁸ s
For striking the plate time is calculated as follows
t = [/tex]
t = 0.67 x 10⁻¹⁸ s