Thank you :))) for the points have a great day
1) divide each percentage by the relative atomic mass of the element
2) divide all results by the smallest number
3)multiply by a whole number to get the simplest whole number ratio (if necessary)
that is to say:
Na S O
32.37÷23 22.58÷32 45.05÷16
= 1.407 = 0.7056 = 2.816 (to 4 significant figures)
the smallest number here is 0.7056 so:
1.407÷0.7056 0.7056÷0.7056 2.816÷0.7056
=1.99 approx.2 = 1 3.99 approx. 4
here there is no need to carry out step 3 as ratio obtained is already a simplest whole number ratio
so empirical formula is: Na₂SO₄
Answer:
Sand
Explanation:
with salt distillation will work, heat the solution and collect the water in a seperate beaker
With sugar you do the same, boil away the water and collect the water vapour, you'll be left with sugar in the original container and water if you collected it
Use a fraction of column and heat the solution, the alcohol will be seperated out
Sand is the only one that uses mechanical filtration
Answer:
According to Le-chatelier principle, equilibrium will shift towards left to minimize concentration of 
and keep same equilibrium constant
Explanation:
In this buffer following equilibrium exists -
So, is involved in the above equilibrium.
When a strong base is added to this buffer, then concentration of increases. Hence, according to Le-chatelier principle, above equilibrium will shift towards left to minimize concentration of and keep same equilibrium constant.
Therefore excess amount of combines with 
to produce ammonia and water. So, effect of addition of strong base on pH of buffer gets minimized.
Properties of matter can be broadly classified into two categories:
Physical properties which usually involve a change in the state of matter and Chemical properties which involve a change in the chemical composition of matter.
Now, physical properties can be further classified as:
Extensive: these depend on the amount of the substance, eg: mass, volume
Intensive: these do not depend on the amount of the substance eg: density, color, melting point, boiling point
Here we are given a 5.0 g and 1 cm3 silver cube :
Therefore:
Extensive properties are-
1) Mass of silver = 5.0 g
2) Volume of silver = 1 cm3
Intensive properties are:
1) Density of silver = mass/volume = 5.0 g/ 1 cm3 = 5.0 g/cm3
2) Melting point of silver = 962 C
3) Color = white/gray
