Answer:
the new pressure is 2.09 atm
Explanation:
you have to use gay lussac's law so the formula is
p1/t1 = p2/t2
and convert C to Kelvin k=C+273.15
1.72atm/294.15 = p2/358.15
solve for p2 by multiplying 358.15 on both sides
p2=2.09 atm
Answer:
Carnivorous plants are easy to grow, if you follow a few, simple rules.
Wet all of the time.
Mineral-free water.
Mineral-free soil.
Lots of light.
Wet all of the time.
Carnivorous plants are native to bogs and similar nutrient-poor habitats. As a consequence, the plants live in conditions that are constantly damp. To grow healthy carnivorous plants, it is important to duplicate their habitat as closely as possible. Keep the soil wet or at least damp all of the time. The easiest way to do this is use the tray method. Set the pots in a tray or saucer, and keep water in it at all times. Pitcher plants can grow in soggy soil with the water level in the saucer as deep as 1/2 the pot, but most carnivorous plants prefer damp to wet soil, so keep the water at about 1/4 inch and refill as soon as it is nearly gone. Water from below, by adding water to the tray, rather than watering the plant. This will avoid washing away the sticky muscilage of the sundews and butterworts and keep from closing the flytraps with a false alarm.
Mineral-free water.
Always use mineral-free water with your carnivorous plants, such as rainwater or distilled water. Try keeping a bucket near the downspout to collect rainwater. Distilled water can be purchased at the grocery store, but avoid bottled drinking water. There are simply too many minerals in it. The condensation line from an air conditioner or heat pump is another source of mineral-free water. Reverse-osmosis water is fine to use. Carnivorous plants grow in nutrient poor soils. The minerals from tap water can “over-fertilize” and “burn out” the plants. In a pinch, tap water will work for a short while, but flush out the minerals with generous portions of rainwater, when it is available.
Mineral-free soil.
The nutrient poor soils to which the carnivorous plants have adapted are often rich in peat and sand. This can be duplicated with a soil mixture of sphagnum peat moss and horticultural sand. Be sure to check the peat label for sphagnum moss. Other types will not work well. The sand should be clean and washed. Play box sand is great, and so is horticultural sand. Avoid “contractor’s sand” which will contain fine dust, silt, clay and other minerals. Never use beach sand or limestone based sand. The salt content will harm the plants. The ratio of the mix is not critical, 1 part peat with 1 part sand works well for most carnivorous plants. Flytraps prefer a bit more sand, and nepenthes prefer much more peat. Use plastic pots, as terra cotta pots will leach out minerals over time and stress your plants.
Explanation:
Kayo na Po bahala magpaigsi
Answer:
Explanation:
yes leon is correct because matter is anything that takes space and also has mass in it.
thks.
Answer:
a) 7.0.
b) Nickel sulfate hepta hydrate.
c) 280.83 g/mol.
d) 44.9%.
Explanation:
<u><em>a) What is the formula of the hydrate?</em></u>
The mass of the hydrated sample (NiSO₄.xH₂O) = 5.0 g,
The mass of the anhydrous salt (NiSO₄) = 2.755 g,
The mass of water = 5.0 g - 2.755 g = 2.245 g.
∴ no. of moles of water = mass/molar mass = (2.245 g)/(18.0 g/mol) = 0.1247 mol.
∴ no. of moles of anhydrous salt (NiSO₄) = mass/molar mass = (2.755 g)/(154.75 g/mol) = 0.0178 mol.
∴ water of crystallization in the sample (x) = no. of moles of water/no. of moles of anhydrous salt (NiSO₄) = (0.1247 mol)/(0.0178 mol) = 7.0.
<u><em>b) What is the full chemical name for the hydrate?</em></u>
The name of the salt (NiSO₄.7H₂O) is Nickel sulfate hepta hydrate.
<u><em>c) What is the molar mass of the hydrate? </em></u>
(NiSO₄.7H₂O)
The molar mass = molar mass of NiSO₄ + 7(molar mass of H₂O) = (154.75 g/mol) + 7(18.0 g/mol) = 280.83 g/mol.
<em><u>d) What is the mass % of water in the hydrate?</u></em>
The mass % of water = (mass of water)/(mass of hydrated sample) x 100 = (2.245 g)/(5.0 g) x 100 = 44.9%.
