Answer:
it is not possible to place the wires in the condui
Explanation:
given data
total area = 2.04 square inches
wires total area = 0.93 square inches
maximum fill conduit = 40%
to find out
Can it is possible place wire in conduit conduit
solution
we know maximum fill is 40%
so here first we get total area of conduit that will be
total area of conduit = 40% × 2.04
total area of conduit = 0.816 square inches
but this area is less than required area of wire that is 0.93 square inches
so we can say it is not possible to place the wires in the conduit
Answer:
See explaination and attachment.
Explanation:
Iteration method is a repetitive method applied until the desired result is achieved.
Let the given equation be f(x) = 0 and the value of x to be determined. By using the Iteration method you can find the roots of the equation. To find the root of the equation first we have to write equation like below
x = pi(x)
Let x=x0 be an initial approximation of the required root α then the first approximation x1 is given by x1 = pi(x0).
Similarly for second, thrid and so on. approximation
x2 = pi(x1)
x3 = pi(x2)
x4 = pi(x3)
xn = pi(xn-1).
please go to attachment for the step by step solution.
Answer:
2.135
Explanation:
Lets make use of these variables
Ox 16.5 kpsi, and Oy --14,5 kpsi
To determine the factor of safety for the states of plane stress. We have to first understand the concept of Coulomb-Mohr theory.
Mohr–Coulomb theory is a mathematical model describing the response of brittle materials such as concrete, or rubble piles, to shear stress as well as normal stress.
Please refer to attachment for the step by step solution.
Answer:
hand tracing
Explanation:
as a programmer when we pretend computer in the debugging process by the step of each statement in recording
then there value of variable is hand tracing because as The hand tracking feature is the use of hands as an input method
so while recording value of each variable each step is hand tracing
The correct statement is: a higher than a normal voltage drop could indicate high resistance. Technician B is correct.
<h3>Ohm's law</h3>
Ohm's law states that the current flowing through a metallic conductor is directly proportional to the voltage provided all physical conditions are constant. Mathematically, it is expressed as
V = IR
Where
V is the potential difference
I is the current
R is the resistance
<h3>Technician A</h3>
High resistance causes an increase in current flow
V = IR
Divide both side by I
R = V / I
Thus, technician A is wrong as high resistance suggest low current flow
<h3>Technician B</h3>
Higher than normal voltage drop could indicate high resistance
V = IR
Thus, technician B is correct as high voltage indicates high resistance
<h3>Conclusion </h3>
From the above illustration, we can see that technician B is correct
Learn more about Ohm's law:
brainly.com/question/796939
