Answer: will you have to do it on your own first
Explanation:
Answer:
greater than 1
Explanation:
The mechanical advantage is the ratio Fr/Fe. So if Fr > Fe, the mechanical advantage is greater than 1.
Answer:
Computation of the load is not possible because E(test) >E(yield)
Explanation:
We are asked to ascertain whether or not it is possible to compute, for brass, the magnitude of the load necessary to produce an elongation of 7.0 mm (0.28 in.). It is first necessary/ important to compute the strain at yielding from the yield strength and the elastic modulus, and then the strain experienced by the test specimen. Then, if
E(test) is less than E(yield), deformation is elastic and the load may be computed. However is E(test) is greater than E(yield) computation/determination of the load is not possible even though defamation is plastic and we have neither a stress-strain plot or a mathematical relating plastic stress and strain. Therefore, we can compute these two values as:
Calculation of E(test is as follows)
E(test) = change in l/lo= Elongation produced/stressed tension= 7.0mm/267mm
=0.0262
Computation of E(yield) is given below:
E(yield) = σy/E=275Mpa/103 ×10^6Mpa= 0.0027
Therefore, we won't be able to compute the load because for computation to take place, E(test) <E(yield). In this case, E(test) is greater than E(yield).
