The correct term for each statement is as follows;
- Caves being formed by acid rain dissolving underground limestone - weathering
- Deltas forming at the mouths of rivers - deposition
- Glaciers scraping rocks across the earth’s surface - erosion
- Rocks being made smooth by tumbling across a stream bed - weathering
- Ponds filling up with sediment and becoming marshes - deposition
<h3>What is weathering?</h3>
Weathering in geology is the mechanical or chemical breaking down of rocks in situ by weather or other causes. options 7 and 14 are the case in this scenario as there is a breakdown of limestone and rocks.
Erosion is the result of having been worn away or eroded, as by a glacier on rock or the sea on a cliff face. Agents of erosion are water, ice or wind. Options 12 is an example of erosion because glaciers are wearing off rocks.
Deposition is the laying down of sediment carried by wind, flowing water, the sea or ice. Sediment can be transported as pebbles, sand and mud, or as salts dissolved in water. Options 8 and 15 are examples of deposition.
Learn more about weathering and deposition at: brainly.com/question/367069
#SPJ1
Table Giving Answer
Element Atomic mass % Amount
Mg_24 24 79 18.96
Mg_25 25 10 2.5
Mg_26 26 11 2.86
Total 24.32
Discussion
The method of calculation for this table, which was done in Excel (a spread sheet) is shown below. Assume that there is 100 grams of material of "pure" magnesium. What is it's mass?
<em><u>Sample Calculation</u></em>
The the sample atomic mass = 24
Mass = % * sample atomic mass
Mass = 79% * 24
Mass = (79/100) * 24
Mass = 18.96
<em><u>Note</u></em>
The other two elements are found exactly the same as the sample calculation.
Then all you do is add the 3 masses together.
Answer
The mass of Mg to 1 decimal place is 24.3 <<<< Answer.
The Molar concentration of your analyte solution is 1.17 m
<h3>What is titration reaction?</h3>
- Titration is a chemical analysis procedure that determines the amount of a sample's ingredient by adding a precisely known amount of another substance to the measured sample, with which the desired constituent reacts in a specific, known proportion.
Make use of the titration formula.
The formula is molarity (M) of the acid x volume (V) of the acid = molarity (M) of the base x volume (V) of the base.
if the titrant and analyte have a 1:1 mole ratio. (Molarity is a measure of a solution's concentration represented as the number of moles of solute per litre of solution.)
26 x 1.8 = 40 x M
M = 26 x1.8 /40
M = 1.17
The Molar concentration of your analyte solution is 1.17 m
To learn more about Titration refer,
brainly.com/question/186765
#SPJ4
Answer:
0°C.
Explanation:
Hello,
In this case, given the heating curve of water on the attached document, we can notice that at 0 °C the solid starts melting, which means that the melting point is reached. Melting point is known as a physical change whereby a solid changes to liquid by the addition of heat as it allows the molecules to separate to each other.
Best regards.