Einsteinium Would be your correct Answer.The electron Configuration [Ra] 7s2 5f8 is Not Valid because Ra is basically 7s2. However, you have Ra 7s2 5f8. You can never repeat an electron.
<h3>The molecular formula of this protein : C₁₈H₄₂O₁₂N₆</h3><h3>Further explanation </h3>
The empirical formula is the smallest comparison of atoms of compound forming elements.
A molecular formula is a formula that shows the number of atomic elements that make up a compound.
(empirical formula) n = molecular formula
The principle of determining empirical formula and molecular formula
- Determine the mass ratio of the constituent elements of the compound.
- Determine the mole ratio by dividing the elemental mass with the relative atomic mass obtained by the empirical formula
- Determine molecular formulas by looking for values of n
Find mol ratio for every component :



N (r=14 g/mol) :
Mass of Nitrogen :
40.4-(17.16+3.17+13.71)=6.36 g

C : H : O : N = 1.43 : 3.17 : 0.857 : 0.454 = 3.15 : 7 : 1.89 : 1=3:7:2:1
Empirical formula : C₃H₇O₂N
Molecular mass of protein :

(C₃H₇O₂N)n=565.75
(12.3+1.7+2.16+14)n=565.75
(89)n=565.75
n=6.4≈6
so the molecular formula : C₁₈H₄₂O₁₂N₆
Answer:
percentage composition of O in HClO IS 30.47
Explanation:
percentage composition of oxygen in HClO =(atomic mass of O)/(atomic mass of HClO)×100
=
=30.47
Answer:
Silica gel chromatography is a s good method for separating these methyl orange and biphenyl because of the wide difference in their polarity. Biphenyl will give a higher Rf value because it is a non-polar and moves faster on silica gel.
Explanation:
Silica gel is very polar, so polar components (like methyl orange) interact with and move slowly it but non polar components (like biphenyl) move faster on silica gel. Looking at their chemical structures, methyl orange has a polar end while biphenyl is a non-polar hydrocarbon. During silica gel chromatography, the methyl orange will interact with silica gel and move slowly but the biphenyl will move fast on the gel because it does not interact with silica gel. This will result to a very distinct separation of the components.
The biphenyl will therefore have a higher Rf value on TLC because it will move faster and longer on the TLC plate.
Answer: C hope this helps Have a wonderful day :)
Explanation: