All categories

3 years ago

Describe How water is tested for color in platinum cobalt method please answer

Engineering

1 answer:

Vikentia [17]3 years ago

4 0

Answer:

The color of water is measured by comparing the water to platinum cobalt color standards representing APHA Standard Color Units. Tests 0, 20, 50, 80, 110, 140, 170, and 200 APHA color units

Explanation:

You might be interested in

An op-amp is connected in an inverting configuration with R1 = 1kW and R2 = 10kW, and a load resistor connected at the output, R

Svetllana [295]

Answer:

View Image

Explanation:

You didn't provide me a picture of the opamp.

I'm gonna assume that this is an ideal opamp, therefore the input impedance can be assumed to be ∞ . This basically implies that...

no current will go in the inverting(-) and noninverting(+) side of the opamp
V₊ = V₋ , so whatever voltage is at the noninverting side will also be the voltage at the inverting side

Since no current is going into the + and - side of the opamp, then

i₁ = i₂

Since V₊ is connected to ground (0V) then V₋ must also be 0V.

V₊ = V₋ = 0

Use whatever method you want to solve for v_out and v_in then divide them. There's so many different ways of solving this circuit.

You didn't give me what the input voltage was so I can't give you the entire answer. I'll just give you the equations needed to plug in your values to get your answers.

8 0

4 years ago

To make 1000 containers of ice cream you need: 600 gallons of milk, 275 gallons of cream, and 120 gallons of flavor. Each ingred

Kamila [148]

Answer:

For the cream, 32 gallons should be reduced and 12 gallons should be decreased for flavor.

Explanation:

To prepare a total of 1000 gallons of ice cream you need 600 gallons of milk, 275 gallons of cream and 120 gallons of flavor, therefore we must calculate the percentages of each ingredient, as follows:

%milk=(600/1000)x100=60%

%cream=(275/1000)x100=27.5%

%flavor=(120/1000)x100=12%

If you reduce the amount of milk by 10% you have:

Milk quantity=600 gallons-(600x0.1)=540 gallons

To maintain the same percentages of each ingredient, you must make a rule of three to know the amount of cream and flavor that would need to be used with the 540 gallons of milk. The rule of three is as follows:

540 gallons of milk------------------60%

x gallons of cream--------------------27.5%

Clearing the x:

x gallons of cream=(540x27.5)/60=243 gallons

In the same way for flavor:

540 gallons of milk------------------60%

x gallons of flavor--------------------12%

Clearing the x:

x gallons of flavor=(540x12)/60=108 gallons

Verifying that they meet the percentages that were calculated before:

Total amount of ice cream=540+243+108=891 gallons

Calculate the percentages of each ingredient:

%milk=(540/891)x100=60.6%

%cream=(243/891)x100=27.3%

%flavor=(108/891)x100=12.1%

As can be seen, it is found that approximately the same percentages calculated above are met. Therefore, we can already calculate the amount by which the cream should be reduced and the flavor.

For the cream:

Gallons of cream=275-243=32 gallons

For the flavor:

Gallons of flavor=120-108=12 gallons

3 0

3 years ago

Hey, I have a question, I was thinking that if you have engineering skills or drawing skill you could help me to start a project

gayaneshka [121]

Answer

Dont have one;(

Explanation:

7 0

3 years ago

Which of the following is an activity of daily living? jogging cleaning weightlifting all of the above

Mrrafil [7]

Answer:

cleaning

Explanation:

4 0

4 years ago

A train consists of a 50 Mg engine and three cars, each having a mass of 30 Mg . If it takes 75 s for the train to increase its

ohaa [14]

Answer:

T = 15 kN

F = 23.33 kN

Explanation:

Given the data in the question,

We apply the impulse momentum principle on the total system,

mv₁ + ∑ $\int\limits^{t2}_{t1} {Fx} \, dt$ = mv₂

we substitute

[50 + 3(30)]×10³ × 0 + FΔt = [50 + 3(30)]×10³ × ( 45 × 1000 / 3600 )

F( 75 - 0 ) = 1.75 × 10⁶

The resultant frictional tractive force F is will then be;

F = 1.75 × 10⁶ / 75

F = 23333.33 N

F = 23.33 kN

Applying the impulse momentum principle on the three cars;

mv₁ + ∑ $\int\limits^{t2}_{t1} {Fx} \, dt$ = mv₂

[3(30)]×10³ × 0 + FΔt = [3(30)]×10³ × ( 45 × 1000 / 3600 )

F(75-0) = 1.125 × 10⁶

The force T developed is then;

T = 1.125 × 10⁶ / 75

T = 15000 N

T = 15 kN

7 0

3 years ago

Describe How water is tested for color in platinum cobalt method please answer ​

Describe How water is tested for color in platinum cobalt method please answer