<span>The wires are suspended diagonally, meaning the tension in each is directed diagonally as well (along the wire). We can, however, talk about the horizontal and vertical components of the tension force. The horizontal tension force in each wire is Tcosθ, while the vertical tension force is Tsinθ.
The horizontal tension forces balance one another, because the wires are pulling in opposite directions. This means Tcosθ=Tcosθ, which is obvious but not very helpful. If you look at the vertical tension forces on the other hand, you can see that they must balance the weight of the body for the system to be in equilibrium. In other words:
Tsinθ+Tsinθ=mg
You're given enough information in the question to solve for T using this equation!</span>
Answer:

Explanation:
given data:
density of water \rho = 1 gm/cm^3 = 1000 kg/m^3
height of water = 20 cm =0.2 m
Pressure p = 1.01300*10^5 Pa
pressure at bottom



= 1.01300*10^5 - 1000*0.2*9.8
= 99340 Pa
h_[fluid} = 0.307m


Answer:
Explanation:
The resistance of a wire can be given by the following expression

where R is resistance , ρ is specific resistance , L is length of wire and A is cross sectional area
specific resistance of metals are almost the same . So in the present case ρ and l are same . Hence the formula becomes
R = k / A where k is a constant .
The diameter of wire becomes two times hence area of cross section becomes 4 times or 4A .
Resistance becomes 1/4 times . Hence if resistance of metal wire is R , resistance of silver wire will be R / 4 .
current = voltage / resistance
In case of metal wire
8 x 10⁻³ = V / R
In case of silver wire
I = V / (R / 4 ) , I is current , V is potential difference .
I = 4 x V/R
= 4 x 8 x 10⁻³ A
= 32 mA.
Answer: Yes indeed it does.
Explanation: Newton's Three Laws of Motion explain how forces create motion in sport. These laws are usually referred to as the Laws of Inertia, Acceleration, and Reaction. maybe brainliest to level up.
Answer:
circuito paralelo
Explanation:
Siempre el circuito en paralelo dara una resistencia menor. Recuerda que las resistencias se suman en el circuito en serie, an cambio en el circuito en paralelo, la corriente se bifurca de manera de circular con mayor intensidad por las ramas que tengan menos resistencia, y tal situacion llevara siempre a producir una menor resistencia equivalente.