Answer:
1 quart (0.9 liters).
Explanation:
A proper inspection of various systems and components in a vehicle at regular intervals is very important and necessary because it helps to ensure that the vehicle is in a safe and reliable condition.
Generally, these inspection includes tyres, lighting systems, fan belts, shock absorbers, fluid (oil and water) level, etc. If any fault or concern is detected in the course of an inspection, it should be noted for quick repair or servicing by an expert technician.
All automobile engine requires an adequate amount of engine oil as a lubricant so as to mitigate friction and enhance proper functionality of the vehicle. Thus, the proper functionality of an engine is largely dependent on the level of the engine oil; it shouldn't be too low or high.
Basically, the engine oil should be checked at regular intervals (periodically) and should be on the level indicated or chosen by the manufacturer of the vehicle.
A dipstick is designed to be used for checking the engine oil level in a vehicle and it is marked with lines indicating minimum and maximum, low and high or add and full.
The difference in quantity between the add and full marks on an engine oil dipstick is typically 1 quart (0.9 liters).
Answer:
222.5 Gpa
Explanation:
From definition of engineering stress, 
where F is applied force and A is original area
Also, engineering strain, 
where l is original area and 
is elongation
We also know that Hooke's law states that 
Since A=20 mm* 20 mm= 0.02 m*0.02 m
F= 89000 N
l= 100 mm= 0.1 m
By substitution we obtain
The modulus of elasticity is 28.6 X 10³ ksi
<u>Explanation:</u>
Given -
Length, l = 5in
Force, P = 8000lb
Area, A = 0.7in²
δ = 0.002in
Modulus of elasticity, E = ?
We know,
Modulus of elasticity, E = σ / ε
Where,
σ is normal stress
ε is normal strain
Normal stress can be calculated as:
σ = P/A
Where,
P is the force applied
A is the area of cross-section
By plugging in the values, we get
σ = 
σ = 11.43ksi
To calculate the normal strain we use the formula,
ε = δ / L
By plugging in the values we get,
ε = 
ε = 0.0004 in/in
Therefore, modulus of elasticity would be:
Thus, modulus of elasticity is 28.6 X 10³ ksi
Answer:
YES
Explanation:
If we connect batteries in series then the output voltage is the sum of the individual voltage of each battery i.e if you connect three 12 volts batteries in series then their output voltage will be 12+12+12=36 volts, but the current rating of the batteries in series will be same of the individual battery rating in 'mah'.
But when we connect the batteries in parallel their voltage is not added but their current rating in mah is addition of their individual rating.
So, If you want 24 volts from three 12 volts battery then you can connect two of them in series and the other one in parallel with them this will give 24 volts and the current will be addition of the two series batteries and the third which is in parallel with them. You can use this configuration if current value is not a big factor.
Answer:
infinite
Explanation:
The tangent of the angle the arm makes with the vertical will be the ratio of the centripetal acceleration to the acceleration due to gravity on the center of mass of the arm. The angle can only be 90° (fully-open arms) if that ratio is infinite.
The speed must be infinite for the arms to be fully open.
