Answer:
5.6 mm
Explanation:
Given that:
A cylindrical tank is required to contain a:
Gage Pressure P = 560 kPa
Allowable normal stress 
= 150 MPa = 150000 Kpa.
The inner diameter of the tank = 3 m
In a closed cylinder there exist both the circumferential stress and the longitudinal stress.
Circumferential stress 
Making thickness t the subject; we have
t = 0.0056 m
t = 5.6 mm
For longitudinal stress.
t = 0.0028 mm
t = 2.8 mm
From the above circumferential stress and longitudinal stress; the stress with the higher value will be considered ; which is circumferential stress and it's minimum value with the maximum thickness = 5.6 mm
Service brake system indicator is the warning that there is something wrong with the service brake system. Hence option f is correct.
<h3>
What is indicator?</h3>
Amber-colored indicator lights can be found at the front, back, and occasionally on the left and right sides of the vehicle. Whether you're turning left, right, or into oncoming traffic, you use your indicators to signal your planned change of direction.
When this light turns on, one of two things will happen. Either the parking brake is engaged or the hydraulic fluid (brake fluid) in the master cylinder is low. Your brakes are made up of a system of hydraulic oil-filled tubes called brake lines.
Thus, service brake system indicator is the warning that there is something wrong with the service brake system. Hence option f is correct.
To learn more about indicator, refer to the link below:
brainly.com/question/28093573
#SPJ1
Answer:
Explanation:
Source Voltage 
Frequency 
Peak output voltage 
Peak Output Voltage with filter 
Generally the equation for Peak to peak voltage is mathematically given by
Therefore
Answer:
Explanation:
We have learned that three things are required for the anodic and cathodic steps of corrosion to occur: an electrolyte, an exposed metal surface, and an electron acceptor. It follows, then, that we can prevent corrosion by removing one of these essential conditions.
Answer:
The answer is "150 
".
Explanation:
Its line length must be converted into wavelengths for the Smith chart to be used.
Because it is an integrated half-wavelength amount,
