sorry i did not mean to answer
The value of the coefficient of kinetic friction between the wagon and inclined surface is 0.78.
<h3>
Coefficient of the kinetic friction</h3>
The value of coefficient of kinetic friction is calculated as follows;
F - Ff = ma
F - μmgcosθ = ma
where;
- F is applied force
- μ is coefficient of kinetic friction
- m is mass of the wagon
- a is acceleration of the wagon
182 - μ(20 x 9.8 x cos30) = 20(2.5)
182 - 169.74μ = 50
182 - 50 = 169.74μ
132 = 169.74μ
μ = 132/169.74
μ = 0.78
Thus, the value of the coefficient of kinetic friction between the wagon and inclined surface is 0.78.
Learn more about coefficient of friction here: brainly.com/question/20241845
Increased lamp voltage is achieved by turning the light intensity dial.
To enlarge the diameter of the hole and let more light through the slide, the iris diaphragm was modified.
Condenser: Position it higher and closer to the slide's bottom to better direct light to the centre of the slide.
<h3>
How do you adjust the light level on a microscope?</h3>
Utilize the brightness adjustment knob to change the brightness. Turn the brightness control knob while looking through the eyepieces to make sure there is no glare in the field of view.
Use a daylight balancing filter if your compound microscope has a certain sort of illumination. It typically rests directly on top of the luminator or in a filter holder above the light. This filter is blue.
The daylight balancing filter will correct the colour temperature and produce a higher-quality image if your microscope is lighted by tungsten or halogen (and a better colour image). This blue filter is not necessary if your microscope is an LED.
To learn more about light level on a microscope, visit:
brainly.com/question/14727797
#SPJ4
Answer:u=42.29 m/s
Explanation:
Given
Horizontal distance=167 m
launch angle
Let u be the initial speed of ball
Range
Explanation:
As it is given that hot pan of copper is dropped into a tub of hot water and the temperature of water rises. This means that heat from the pan has been released and this heat is gained by water.
As a result, temperature of copper pan has decreased and this decrease will continue till the time temperature of both copper pan and water will reach the same temperature.
As thermal energy is defined as the energy in which when two objects come in physical contact with each other then no exchange of heat energy will take place.
Thus, we can conclude that when temperature of both copper pan and water will be equal then it means that both of them has reached thermal equilibrium.
