How many loads can be connected in series per line in a control circuit in which a switch is use as to control the loads?
1 answer:
You might be interested in
Solution :
Methods for selling pressure of a distillation column :
a). Set, the overhead stream using cooling water.
(minimum of approximate 45°C condenser temperature)
b). Set, of bottom product that avoids decomposition or reaction.
c). Set, not utility for reboiler.
Running the distillation column above the ambient pressure because :
The components to be distilled have very high vapor pressures and the temperature at which they can be condensed at or below the ambient pressure.
Run the reactor at an evaluated temperature because :
a). The rate of reaction is taster. This results in a small reactor or high phase conversion.
b). The reaction is endothermic and equilibrium limited increasing the temperature shifts the equilibrium to the right.
Run the reaction at an evaluated pressure because :
The reaction is gas phase and the concentration and hence the rate is increased as the pressure is increased. This results in a smaller reactor and /or higher reactor conversion.
The reaction is equilibrium limited and there are few products moles than react moles. As increase in pressure shifts the equilibrium to the right.
- Answer: Explanation: Application of the bernoulli's equation comes in from conservation of mass flow. The cross sectional area of the two pipes are calculated. from A = πD²/4 The velocity of water from conservation of mass flow is also calculated ; V2 = Ac1V1/Ac2 The Loss coefficient is then calculated from KL = (1 - Ac1²/Ac2²)² Then the head Loss (hL) is calculated The detailed calculated and appropriate steps is as shown in the attached files.
