The maintenance is in charge of controlling that all the machines of a company are constantly running in order to avoid damages that cause loss of money when the machines fail.
The maintenance based on vibration monitoring allows to predict failures in some rotating machines such as:
1. worn bearings
2.alignment
3.balance
4. affected gears
5. bent shafts
6. rocks
7.gags
8. eccentricity
9. failures of electrical origin
Answer:
(a) Calculate the field, armature, and load currents versus load = 306A
(b) Determine the terminal voltage at no-load and at rated load conditions = 300V
(c) Calculate the voltage regulation of the generator. Use the no-load voltage as the base value = 6.67%
(d) Plot the terminal voltage as a function of the load. Determine the load that corresponds to a 5% voltage drop using the no-load voltage as the base = 294.74V
Explanation:
CHECK THE ATTACHED FILES FOR DETAILED EXPLANATION.
What torque specs to heads bolts need to be at for a 76 small block chevy is given below
Explanation:
1.Always torque bolts in three equal increments
Bolts or Parts Lube or Sealer Torque to:
Cylinder Heads Engine oil (blind hole) Sealer (water jacket) 65 ft-lbs.
Rocker Studs (screw-in) Engine Oil 50 ft-lbs.
2.Intake Manifold to Cylinder Head
- In the GM 350-cubic-inch engine, the intake manifold bolts to the cylinder head with 33 foot-pounds of torque.
3.Torque the head bolts in the same manner in three stages. Start by tightening all the bolts in sequence to 45 pounds of torque, then to 75 and finally to the torque recommended. Depending on the type of head you are installing, the final torque number will be different.
4.Bolts with any signs of damage, no matter how slight, should never be reused. Not only will the bolts eventually fail, but when they do, there is the potential for them to cause damage to your cylinder head. This results in a much more expensive repair than simply replacing the bolts in the first place.
5.The Chevy 350 engine is a 350 cubic inch (5.7-liter) small block V8 with a 4.00 and 3.48 inch bore and stroke. Depending on the year, make and model of a car, horsepower ranges from approximately 145 to more than 370.
harden you could either me or leave
harden you could either me or leave
Xharden you could either me or leave
harden you could either me or leave
BBB
harden you could either me or leave
GO WATCH AFTER OUT NOW RADDED RB
harden you could either me or leave
harden you could either me or leave
harden you could either me or leave
harden you could either me or leave
GO WATCH AFTER OUT NOW RADDED R
harden you could either me or leave
GO WATCH AFTER OUT NOW RADDED R
harden you could either me or leave
harden you could either me or leave
GO WATCH AFTER OUT NOW RADDED R